From the east coast to the west coast, north to south, each of our NationServe locations has a team of experienced, professional, and friendly technicians ready to serve you. Our team is trained to service all industry products and will find a proper solution for even the most difficult issues. Every installation and repair is completed in accordance with industry safety standards. Many of our locations are also affiliated with professional organizations including the International Door Association, Better Business Bureau, their local Chamber of Commerce, and the National Association of Home Builders.
LED & Florescent lights: I hear you asking “why is this important?”. Both can emit radio and electromagnetic interference that can mask the signal between the smart hub and your opener. If you experience unreliable operation - out they go. The last thing I did was remove an LED lamp from a motion sensor fixture nearby and replaced it with a standard incandescent. Since the light is only on for a few minutes I’m not worried about the power usage if it means the garage door will close when commanded. Click Here for Garage Door Repairs
Now check the springs. There will be just one on a single-car garage, two on a two-car garage. Roll-up doors are operated by torsion springs, controlled by cables on pulleys. Two-car models can be adjusted by pulling the cable further through the plate above the door, then knotting the end to hold the newly established tension. One-car roll-up door springs should only be adjusted by a professional, as there is such a great amount of tension on the one spring that you could be injured when trying to adjust it yourself. Swing-up door springs are hooked on each side of the door into special notches or holes. To adjust the tension on these springs, simply move the spring hooks to the next notch.
Hii need you guys help! Once my thermostat drop below the set temp , my furnace does not turn on and I was wondering what’s wrong with it. It happens mostly on cold nights. Sometimes I would have to go in the basement and turned the furnace power switch off then on and will come on once I switch it off then on.i also change the thermostat recently, so I don’t think that’s the problem
I discovered that the RF transmitter in the smart hub is fairly weak. While your car can transmit a signal a half block away, the smart hub can't. The instructions make a recommendation for placement of the smart hub but will make an explicit statement here - install it within the 4-6’ “recommendation”. Consider this when planning your installation. Apparently, orientation is important for maximum reach. If it doesn’t work reliably, flip it 180 degrees on its mount. Finally, like other garage door remotes, if it loses power you might have to re-program the system with the garage door learn button. They don’t tell you this so I will.
Dealing with a garage door that needs a repair service can be a frustrating experience. That why we are committed to exceeding your garage door repair service in Naperville, IL expectations. Our reputation is built from thousands of satisfied customers over the past 30 plus years in the Western Suburbs of Chicago. Whether it is a broken spring, or a garage door opener that need a repair, make us your first call in Naperville, IL.
This is the first time using precision to fix my garage door. From the call to schedule an appointment to the work that was done, all went smoothly. They got a technician out the same day and within a few hours. My garage door got damaged pretty bad and I thought I was going to have to replace the whole door or that they would try and sell me on buying one, but Jimmy the technician, which by the way a very personable and knowledgeable guy, took the time to explain and show me what needed to be replaced (drums, cables and springs) and why without trying to sell me on anything I didn't need. He also took the time to show me how to do proper maintenance on the door so that it last longer. Once he finished he noticed that the belt on my garage door opener was about to break and pointed it out to me, which I'm happy he did. That could have been a costly expense if not caught early. I like that he didn't mind me watching and asking questions the whole time he was here or tried to sell me on anything I didn't need. He took his time and made sure the door was working properly, which my husband and I feel it works better now then it ever had before. It opens and closes more smoothly and quietly. Jimmy also left everything clean and finished in a timely matter. I highly recommend this company and Jimmy!
When the lay-person typically sees a circuit board, they immediately seize up and think that's it's too advanced for them to fix. In reality, replacing circuit boards for the Chamberlain Liftmaster, Sears, and Craftsman garage door openers is relatively easy with proper instruction. This video will walk you through the process of replacing the circuit board on a Chamberlain Liftmaster, Sears, and Craftsman garage door opener.
While you may be able to increase efficiency by replacing the weather stripping at the bottom of an old garage door, the kind of insulation and energy efficient materials used in today’s new doors will make a drastic improvement on your garage’s energy efficiency. Just like the way a new garage door recoups its costs in increased home value, a new door will also quickly pay for itself in energy savings!
Because it was a Saturday and I knew the garage door company I usually use wasn't open week-ends. I decided to look on the internet for week-end workers. The first site that came up was Precision Overhead Garage. Their website said if you call before noon, you can get an appointment that day. Even though it was 1pm, I decided to call anyway. After explaining that I couldn't close or open my garage door, they told me they would go ahead and schedule a time that day...even though it was after their same-day service cut off time of noon. They told me the technician would arrive between 3pm-5pm and he would call before coming (that was nice because I was able to run errands locally and not have to wait at home for those 2 hours). I also have to mention that although the company used an answering service to take the call and schedule the appointment, the gentleman that helped me was also very professional and courteous. Derrick, the technician that was assigned to the repair, called to tell me he was on his way. It was also within the arrival timeframe the company had promised. When he got to my house, he was polite and professional. He assessed the problem and made sure that I was clear about the cost of the repair and the cost of the service call. I agreed and he immediately went to work. He never tried to sell me any other services or parts or repairs that weren't needed. He was finished within 45 minutes and the door worked perfectly. I was able to pay with a credit card even without them being able to verify the information because it was a week-end. I was very impressed that they did that, especially because I was a new customer and had no history with them. Obviously, by my 5-star rating, I would recommend them to anyone who is looking for a professional garage door company. Thank you to Derrick and Precision Overhead Garage Door Service!!